TI-1210-4 (REVISION C & LATER) video card Settings and Configuration

Category	Video
Video Types Supported	XVGA
Video Processor	TMS34010
Highest Resolution Supported	1280 x 1024
Data Bus Type	16-bit ISA
Memory Type	DRAM/VRAM
Maximum Onboard Memory	512KB DRAM, 1536KB VRAM

CONNECTIONS
Purpose	Location	Purpose	Location
9-pin video analog port	CN1	VGA Pass-Through connector	CN2

FACTORY CONFIGURED - DO NOT ALTER
Jumper	Position
J2	Open

BASE ADDRESS SELECTION
Address		J62	J63	J64	J65	J66	J67	J68	J69
»	C700h	Open	Open	Closed	Closed	Open	Open	Open	Closed
	CC00h	Open	Open	Closed	Closed	Closed	Closed	Open	Open
	CF00h	Open	Open	Closed	Closed	Open	Open	Open	Open
	D700h	Open	Open	Closed	Open	Open	Open	Open	Closed
	DF00h	Open	Open	Closed	Open	Open	Open	Open	Open

EMULATION CONFIGURATION
Setting		J7
»	Enabled	Open
	Disabled	Closed

VGA PASS-THROUGH CONFIGURATION
Setting		JX1
»	Disabled	Open
	Enabled	Closed
Note: Emulation jumper (J7) must be disabled when VGA Pass-Through is enabled.

FOURTH CABLE OUTPUT SYNC SELECTION
Output from VGA		Output from TI-1210-4	J4	J6
»	Composite sync signal	Composite sync signal	Pins 1 & 2 closed	Pins 1 & 2 closed
	Separate horizontal sync	Separate horizontal sync	Pins 2 & 3 closed	Pins 2 & 3 closed

HOST BUS INTERRUPT SELECTION
IRQ		J10	J11	J12	J13	J14
»	Disabled	Open	Open	Open	Open	Open
	3	Open	Open	Open	Open	Pins 1 & 2
	4	Open	Open	Open	Pins 1 & 2	Open
	5	Open	Open	Pins 1 & 2	Open	Open
	6	Open	Pins 1 & 2	Open	Open	Open
	7	Pins 1 & 2	Open	Open	Open	Open
	10	Open	Open	Open	Open	Pins 2 & 3
	11	Open	Open	Open	Pins 2 & 3	Open
	12	Open	Open	Pins 2 & 3	Open	Open
	14	Open	Pins 2 & 3	Open	Open	Open
	15	Pins 2 & 3	Open	Open	Open	Open
Note: Pins designated should be in the closed position.