E5001 Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Star
Wiring Type	Unshielded twisted pair AUI transceiver via DB-15 port
Boot ROM	Available

INTERRUPT REQUEST
IRQ		JP1A	JP1B	JP1C	JP1D	JP1E
	2/9	Closed	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open
	6	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Closed

CABLE TYPE
Type		SW1/1
»	Unshielded twisted pair	On
	AUI transceiver via DB-15 port	Off

LINK INTEGRITY TEST
Setting		JP31
»	Enabled	Pins 1 & 2 Closed
	Disabled	Pins 2 & 3 Closed
Note:Link Integrity is only used with 10Base-T wiring. When using an AUI transciever, the test should be disabled.

I/O BASE ADDRESS
Address		SW1/3	SW1/4
»	300-31Fh	On	On
	320-33Fh	Off	On
	340-35Fh	On	Off
	360-37Fh	Off	Off

BOOT ROM ADDRESS
Address	SW1/5	SW1/6	SW1/7	SW1/8
Disabled	Off	Off	Off	Off
C4000h	On	On	On	Off
C8000h	Off	On	On	Off
CC000h	On	Off	On	Off
D0000h	Off	Off	On	Off
D4000h	On	On	Off	Off
D8000h	Off	On	Off	Off
DC000h	On	Off	Off	Off

DIAGNOSTIC LED(S)
LED	Link Integrity	Status	Condition
LED1	Enabled	On	Twisted pair network connection good
LED1	Enabled	Off	Twisted pair network connection broken
LED1	Disabled	On	Data is being received power
LED1	Disabled	Off	Data is not being received power
Note:The condition shown by LED1 depends on the setting of the link integrity test switch SW1/2. (see above)