MACCON+SE Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	PDS
Topology	Linear Bus/Star
Wiring Type	Unshielded twisted pair AUI Transceiver via DB-15 port RG-58A/U 50ohm coaxial
Boot ROM	Not available

CONNECTIONS
Purpose	Function
Bus connector	CN1
Interface Module Connector	CN2

CONNECTIONS
Purpose	Function
Controller board connector	CN3

CABLE TYPE SELECTION
Cable Type	SW1
RG-58A/U 50ohm coaxial	Off
AUI Transceiver via DB-15 port	On

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Red	On	Network activity detected
LED1	Red	Off	Network activity not detected

CONNECTIONS
Purpose	Location
Controller card connector	CN4

CABLE TYPE SELECTION
Cable Type	SW2
Unshielded twisted pair, link enabled	position 1
Unshielded twisted pair, link disabled	position 2
AUI Transceiver via DB-15 port	position 3

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED2	Red	On	Network activity detected
LED2	Red	Off	Network activity not detected
LED3	Green	On	Network connection is good
LED3	Green	Off	Network connection is broken