CN825E REV. B Network Card Settings and Configuration

NIC Type	Transceiver
Transfer Rate	Unidentified
Data Bus	Transceiver
Topology	Linear Bus
Wiring Type	AUI Transceiver via DB-15 port Fiber optic cable
Boot ROM	Not available

SQE CONFIGURATION
Select	SW1
Enabled	Position 1
Disabled	Position 2
Loopback test	Position 3

DIAGNOSTIC LED(S)
LED	Status	Condition
LED1	On	Network connection is good
LED1	Off	Network connection is broken
LED2	On	Network traffic detected
LED2	Blinking	Data is being received
LED2	Off	Data is not being received
LED3	On	Large load of data is being received
LED3	Blinking	Normal load of data is being transmitted
LED3	Off	Data is not being transmitted
LED4	On	Twisted-pair to transceiver connection broken
LED4	Blinking	Collision detected on port
LED4	Off	No collision is detected