NETWORK ADAPTER (P/N D8611) Network Card Settings and Configuration

NIC Type	D-Link Network, Proprietary
Transfer Rate	1Mbps
Data Bus	8-bit ISA
Topology	Linear bus
Wiring Type	Unshielded twisted pair
Boot ROM	Available

NODE ADDRESS
Node	SW1/1	SW1/2	SW1/3	SW1/4	SW1/5	SW1/6	SW1/7	SW1/8
0	On	On	On	On	On	On	On	On
1	On	On	On	On	On	On	On	Off
2	On	On	On	On	On	On	Off	On
3	On	On	On	On	On	On	Off	Off
4	On	On	On	On	On	Off	On	On
251	Off	Off	Off	Off	Off	On	Off	Off
252	Off	Off	Off	Off	Off	Off	On	On
253	Off	Off	Off	Off	Off	Off	On	Off
254	Off	Off	Off	Off	Off	Off	Off	On
255	-	-	-	-	-	-	-	-
Notes: Node address 0 is used for messaging between nodes and must not be used. A total of 255 node address settings are available. The switches are a binary representation of the decimal node addresses. Switch 1 is the Least Significant Bit and switch 8 is the Most Significant Bit. The switches have the following decimal values: switch 1=128, 2=64, 3=32, 4=16, 5=8, 6=4, 7=2, 8=1. Turn off the switches and add the values of the off switches to obtain the correct node address. (On=0, Off=1)

INTERRUPT REQUEST
IRQ		JP1A	JP1B	JP1C	SW2/1
»	2	N/A	N/A	N/A	Off
	3	Closed	Open	Open	On
	4	Open	Closed	Open	On
	5	Open	Open	Closed	On
Note:If the card is installed in a PC/AT compatible the IRQ should be IRQ5, IRQ3, or IRQ4. You should try the interrupts in that order.

ONBOARD TERMINATOR
Setting		JP2A	JP2B
»	Disabled	Open	Closed
	Enabled	Closed	Open
Note:If the card is on either end of a linear bus network segment, the onboard terminator may be

BOOT ROM ADDRESS
Address		Software Parameter	JP3A	JP3B
»	CC000 - CFFFFh	HC	Open	Closed
	DC000 - DFFFFh	HD	Closed	Open
Note:The software parameter is used in the DEVICE= statement in the CONFIG.SYS file (e.g. DEVICE = D-LINK.DRV /HC).

DMA CHANNEL
Channel		SW2/2
»	DMA1	Off
	DMA3	On

I/O BASE ADDRESS
Address		SW2/3	SW2/4
	240h	Off	On
	260h	Off	Off
	340h	On	On
»	360h	On	Off

BOOT ROM
Setting		SW2/6
»	Disabled	Open
	Enabled	Closed

FACTORY CONFIGURED SETTINGS
Switch	Setting
SW2/5	Unused