105T Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear bus
Wiring Type	RG58A/U 50ohm coaxial AUI transceiver via DB-15
Boot ROM	Available

I/O /BOOT ROM ADDRESS
I/O Address		Boot ROM	W1	W2	W3
»	300h	None	Open	Closed	Closed
	300h	C8000-CBFFFh	Closed	Closed	Closed
	320h	None	Open	Closed	Open
	320h	CC000-CFFFFh	Closed	Closed	Open
	340h	None	Open	Open	Closed
	340h	D0000-D3FFFh	Closed	Open	Closed
	360h	None	Open	Open	Open
	360h	D4000-D7FFFh	Closed	Open	Open

WAIT STATE CONFIGURATION
Wait State(s)	W4
1 wait state	Open
0 wait states	Closed

CABLE TYPE
Type		W5	W6-W11	W13
»	RG58A/U 50ohm coaxial	Pins 2 & 3 closed	Pins 2 & 3 closed	Pins 2 & 3 closed
	AUI transceiver via DB-15 port	Pins 1 & 2 closed	Pins 1 & 2 closed	Pins 1 & 2 closed
Note:Revision D of the EXOS 105T board reversed the polarity of W13. Therefore, if you have a revision D board, settings for W13 will be opposite those shown.

SIGNAL QUALITY
Function		W12
»	Signal quality test enabled	Pins 2 & 3 closed
	Signal quality test disabled	Pins 1 & 2 closed

DMA CHANNEL
Channel	W14	W15	W16	W17	W18	W19	W23	W24
DMA3	Open	Open	Open	Open	Open	Open	Closed	Closed
DMA5	Open	Open	Open	Open	Closed	Closed	Open	Open
DMA6	Open	Open	Closed	Closed	Open	Open	Open	Open
DMA7	Closed	Closed	Open	Open	Open	Open	Open	Open

INTERRUPT SETTINGS
IRQ	W20	W21	W22	W25
None	Open	Open	Open	Open
2/9	Open	Open	Open	Closed
3	Closed	Open	Open	Open
4	Open	Closed	Open	Open
5	Open	Open	Closed	Open