CS-ETHERNET-KARTE COMBO (REV. C.1/C.1 PLUS) Network Card Settings and Configuration
COMPU-SHACK PRODUCTION, GMBH
CS-ETHERNET-KARTE COMBO (REV. C.1/C.1 PLUS)
NIC Type: | Ethernet |
Transfer Rate: | 10Mbps |
Data Bus: | 16-bit ISA |
Topology: | Linear Bus Star |
Wiring Type | AUI transceiver via DB-15 port RG58A/U 50ohm coaxial Shielded/unshielded twisted pair |
Boot ROM | Available |
INTERRUPT SELECT - J1 | |||||||||
IRQ | A | B | C | D | E | F | G | H | |
| » | IRQ3 | Open | Open | Open | Open | Open | Open | Open | Closed |
IRQ4 | Open | Open | Open | Open | Open | Open | Closed | Open | |
IRQ5 | Open | Open | Open | Open | Open | Closed | Open | Open | |
IRQ7 | Open | Open | Open | Open | Closed | Open | Open | Open | |
IRQ9 | Open | Open | Open | Closed | Open | Open | Open | Open | |
IRQ10 | Open | Open | Closed | Open | Open | Open | Open | Open | |
IRQ11 | Open | Closed | Open | Open | Open | Open | Open | Open | |
IRQ12 | Closed | Open | Open | Open | Open | Open | Open | Open | |
CARD EMULATION - J2 | ||||
Setting | Jumper A | Jumper B | Jumper C | Jumper D |
NE1000 mode | Open | Closed | Open | Open |
NE2000 mode | Closed | Open | Open | Open |
CS 16KB mode | Open | Open | Closed | Open |
CS 64KB mode | Open | Open | Open | Closed |
WIRING TYPE SELECT - J5 | ||||||
Setting | Jumper A | jumper B | Jumper C | Jumper D | Jumper E | Jumper F |
BNC | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed |
AUI | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed |
BOOT ROM INSTALLATION | |||
Setting | J6 | J7 | |
| » | Install in IBM PC compatible | Pins 2 & 3 closed | Pins 2 &3 closed |
Install in IBM AT compatible | Pins 1 & 2 closed | Pins 1 & 2 closed | |
SOFTWARE COMPATIBILITY/BUS SELECT | |
Setting | J8 |
NE1000 or NE2000/8-bit PC or AT slot | All pins open |
NE2000/8-bit PC or 16-bit AT slot or CS-format/16-bit AT slot | Pins 1 & 3 closed |
NE2000/16-bit AT slot | Pins 3 & 4 closed |
BNC TYPE | |||
Setting | J9/jumper A | J9/jumper B | |
| » | RG58A/U 50ohm coaxial | Pins 2 & 3 closed | Pins 2 &3 closed |
RG62A/U 93ohm coaxial | Pins 1 & 2 closed | Pins 1 & 2 closed | |
WIRING TYPE SELECT - J14 | ||||||
Setting | Jumper A | jumper B | Jumper C | Jumper D | Jumper E | Jumper F |
BNC | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed | 1 & 2 closed |
UTP | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed | 2 & 3 closed |
Note:J14 should be set to the BNC setting if J5 is also. | ||||||
PAL MODES | |
Setting | J16 |
PAL P12EATW3/P12EATB3 compatible | Open |
PAL P12EATW/P12EATB compatible | Closed |
Note: This jumper applies to the CS-Ethernet COMBO Rev. B.4 only. | |
I/O ADDRESS | |||||
Address | SW1/1 | SW1/2 | SW1/3 | SW1/4 | |
| » | 300h | Off | On | On | On |
200h | On | On | On | On | |
220h | On | On | On | Off | |
240h | On | On | Off | On | |
260h | On | On | Off | Off | |
280h | On | Off | On | On | |
2A0h | On | Off | On | Off | |
2C0h | On | Off | Off | On | |
2E0h | On | Off | Off | Off | |
320h | Off | On | On | Off | |
340h | Off | On | Off | On | |
360h | Off | On | Off | Off | |
380h | Off | Off | On | On | |
3A0h | Off | Off | On | Off | |
3C0h | Off | Off | Off | On | |
3E0h | Off | Off | Off | Off | |
BOOT ROM ADDRESS | |||||
Address | SW1/5 | SW1/6 | SW1/7 | SW1/8 | |
| » | Disabled | N/A | N/A | N/A | Off |
C0000h | On | On | On | On | |
C4000h | On | On | Off | On | |
C8000h | On | Off | On | On | |
CC000h | On | Off | Off | On | |
D0000h | Off | On | On | On | |
D4000h | Off | On | Off | On | |
D8000h | Off | Off | On | On | |
DC000h | Off | Off | Off | On | |
DIAGNOSTIC LEDS | ||
LED | Status | Condition |
D1 | On | Twisted pair network connection is good |
D2 | On | Twisted pair network connection is broken |
D3 | On | Collision detected on network |
D4 | On | Data is being transmitted (UTP connection only) |
D5 | On | Data is being received (UTP connection only) |
My Books
