G/ETHERNET 16 ADAPTER Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear Bus Star
Wiring Type	RG--58A/U 50ohm coaxial AUI transceiver via DB-15 port Shielded Unshielded twisted pair
Boot ROM	Available

CABLE TYPE
Type		JP4A - JP4D
»	RG-58A/U 50ohm coaxial	Closed
	AUI transceiver via DB-15 port	Open

COMPATIBILITY MODE
Setting		JP5
»	Normal operation	Pins 1 & 2 Closed
	Compatibility mode	Pins 2 & 3 Closed
Note:If the system locks up, experiances boot failures, or continues network error messages then use the

INTERRUPT REQUEST
IRQ		JP6	JP7	JP8	JP9	JP10	JP11	JP12	JP13	JP14	JP15
»	3	Open	Closed	Open	Open	Open	Open	Open	Open	Open	Open
	2/9	Closed	Open	Open	Open	Open	Open	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open	Open	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open	Open	Open	Open	Open
	6	Open	Open	Open	Open	Closed	Open	Open	Open	Open	Open
	7	Open	Open	Open	Open	Open	Closed	Open	Open	Open	Open
	10	Open	Open	Open	Open	Open	Open	Closed	Open	Open	Open
	11	Open	Open	Open	Open	Open	Open	Open	Closed	Open	Open
	12	Open	Open	Open	Open	Open	Open	Open	Open	Closed	Open
	15	Open	Open	Open	Open	Open	Open	Open	Open	Open	Closed

I/O BASE ADDRESS
Address		SW1/1	SW1/2	SW1/3	SW1/4
»	2A0h-2BFh	On	Off	On	On
	280h-29Fh	On	On	On	On
	2C0h-2DFh	On	On	Off	On
	2E0h-2FFh 1	On	Off	Off	On
	300h-31Fh	On	On	On	Off
	320h-33Fh	On	Off	On	Off
	340h-35Fh	On	On	Off	Off
	360h-37Fh 1	On	Off	Off	Off
	Note 1 :Not valid when controller uses boot ROM with part number 83020036-05 or greater.

BOOT ROM ADDRESS
Address		SW1/5	SW1/6
»	CC000-CFFFFh	Off	Off
	C0000-C3FFFh	On	On
	C4000-C7FFFh	Off	On
	C8000-CBFFFh	On	Off

MISCELLANEOUS NOTES

Different drivers must be used for the National & the Fujitsu chipset cards, they are not interchangeable.